RTI: Difference between revisions

Revision as of 23:24, 10 August 2024


Basic Info
Addressing Mode	Opcode	Length	Speed
Stack (RTI)	40	1 byte	7 cycles*


Flags Affected
	N	V	M	X	D	I	Z	C
65c816 native mode	N	V	M	X	D	I	Z	C
6502 emulation mode	N	V	.	.	D	I	Z	C

RTI (ReTurn from Interrupt) is a 65x instruction used to return control from an interrupt handler. It does this by first pulling the status flags off of the stack and then the program counter too. In native mode, the program bank register is pulled after that for a total of 4 bytes. In emulation mode, 3 bytes are pulled.

Syntax

RTI

Page 493 of Eyes & Lichty has the old status register diagrammed as being four bytes deeper than the top of the stack before RTI, but the text on the previous page (and the bsnes source code) have the status register being pulled first.

Pitfalls

RTI should only be run when the e flag is in the same state as when the interrupt fired
RTI cannot even tell whether the interrupt actually occurred or not
RTI does not increment the program counter after pulling it like RTS and RTL do

Cycle Skipped

RTI takes one fewer cycle in emulation mode as the program bank register doesn't need to be pulled from the stack.

External Links

Eyes & Lichty, page 492 on RTI
Labiak, page 176 on RTI
9.6 on MCS6500 Manual, page 132 on RTI
Carr, page 270 on RTI
Leventhal, page 3-89 on RTI
snes9x implementation of RTI: https://github.com/snes9xgit/snes9x/blob/master/cpuops.cpp#L3272
undisbeliever on RTI: https://undisbeliever.net/snesdev/65816-opcodes.html#rti-return-from-interrupt
Pickens, John. http://www.6502.org/tutorials/6502opcodes.html#RTI
Clark, Bruce. http://www.6502.org/tutorials/65c816opcodes.html#6.3.2
lbid, APPENDIX: EMULATION MODE, http://www.6502.org/tutorials/65c816opcodes.html#APPENDIX:

@@ Line 63: / Line 63: @@
 ===== Cycle Skipped =====
 RTI takes one fewer cycle in [[emulation mode]] as the [[program bank register]] doesn't need to be pulled from the [[stack]].
+[[File:rti.png]]
 === See Also ===