We've just updated MediaWiki and its underlying software. If anything doesn't look or work quite right, please mention it to us. --RanAS

MOV1 (SPC700): Difference between revisions

From SnesLab
Jump to: navigation, search
(3 byte Instructions)
(→‎External Links: applicable memory location)
Line 62: Line 62:
=== External Links ===
=== External Links ===
* Official Super Nintendo development manual on MOV1: Table C-18 in [https://archive.org/details/SNESDevManual/book1/page/n234 Appendix C-9 of Book I]
* Official Super Nintendo development manual on MOV1: Table C-18 in [https://archive.org/details/SNESDevManual/book1/page/n234 Appendix C-9 of Book I]
* https://archive.org/details/SNESDevManual/book1/page/n186


[[Category:ASM]]
[[Category:ASM]]

Revision as of 05:16, 18 December 2023

Basic Info
Addressing Mode Opcode Length Speed
13-bit Absolute AA 3 bytes 4 cycles
13-bit Absolute CA 3 bytes 6 cycles
Flags Affected
Direction N V P B H I Z C
to carry . . . . . . .
from carry . . . . . . . .

MOV1 is an SPC700 command that moves a memory bit to or from the carry flag. The low 13 bits of the operand byte specify an absolute address. The high 3 bits of the operand byte specify which bit at that absolute address.

The operands are stored in the instruction stream in the opposite order they appear in the assembler source. In the assembler source, the operand on the right is the source and the operand on the left is the destination.

See Also

External Links