FMULT (Super FX): Difference between revisions
(blurb about specifying sreg/dreg in advance) |
|||
| Line 44: | Line 44: | ||
FMULT shares its multiplication circuit with [[LMULT]]. | FMULT shares its multiplication circuit with [[LMULT]]. | ||
The source and destination registers should be specified in advance using [[WITH]], [[FROM]], or [[TO]]. Otherwise, R<sub>0</sub> serves as the default. | |||
==== Syntax ==== | ==== Syntax ==== | ||
Revision as of 18:38, 9 July 2024
| Basic Info | |||||||
|---|---|---|---|---|---|---|---|
| Addressing Mode | Opcode | Length | ROM Speed | RAM Speed | Cache Speed | ||
| Implied (type 1) | 9F | 1 byte | 7 or 11 cycles | 7 or 11 cycles | 4 or 8 cycle | ||
| Flags Affected | ||||||||
|---|---|---|---|---|---|---|---|---|
| B | ALT1 | ALT2 | O/V | S | CY | Z | ||
| 0 | 0 | 0 | . | |||||
FMULT (fractional multiply) is a Super FX instruction that performs a signed multiplication. The two factors are the source register and R6. The upper 16 bits of the 32-bit product are stored in the destination register. Bit 15 of the product is stored in CY. The lower 15 bits of the product appear to be discarded.
The exact speed depends on the state of the CFGR register. FMULT utilizes the 8-bit multiplier four times.[3]
R4 cannot serve as the destination register, but any other register from R0 to R15 can. If R4 is specified as the destination register anyway, the product will simply not be written to it and will be lost instead.[3]
FMULT shares its multiplication circuit with LMULT.
The source and destination registers should be specified in advance using WITH, FROM, or TO. Otherwise, R0 serves as the default.
Syntax
FMULT
Example
Let:
Sreg : R5 Dreg : R2 R5 = 4aaah R6 = daabh
After executing FMULT:
R2 = f51ch
and the carry flag and sign flag are set
See Also
External Links
- Official Nintendo documentation on FMULT: 9.33 on Page 2-9-46 of Book II
- example: page 2-9-47, lbid.
- 8.2 "Multiplication Instructions" on page 2-8-16, lbid.