DI (SPC700): Difference between revisions

Latest revision as of 00:18, 14 August 2024


Basic Info
Addressing Mode	Opcode	Length	Speed
Implied (type 2)	C0	1 byte	3 cycles


Flags Affected
N	V	P	B	H	I	Z	C
.	.	.	.	.	0	.	.

DI (Disable Interrupts) is an SPC700 instruction that clears the interrupt enable flag.

As the S-SMP has no hardware interrupt sources, DI is not very useful.

No other flags are affected.

DI

The official manual has a typo where the zero flag is cleared instead.

@@ Line 14: / Line 14: @@
 {| class="wikitable" style="float:right;clear:right;width:30%"
-!colspan="8"|Flags Clobbered
+!colspan="8"|Flags Affected
 |+
-|N
+|[[Negative Flag|N]]
-|V
+|[[Overflow Flag|V]]
-|P
+|[[Direct Page Flag|P]]
-|B
+|[[Break Flag|B]]
-|H
+|[[Half-Carry Flag|H]]
-|I
+|[[Interrupt Enable Flag|I]]
-|Z
+|[[Zero Flag|Z]]
-|C
+|[[Carry Flag|C]]
 |+
 |.
@@ Line 37: / Line 37: @@
 '''DI''' (Disable Interrupts) is an [[SPC700]] instruction that clears the [[interrupt enable flag]].
-The manual has a typo where the flag which is cleared is in the [[zero flag]]'s position instead.
+As the [[S-SMP]] has no hardware interrupt sources, DI is not very useful.
+No other flags are affected.
+==== Syntax ====
+<pre>
+DI
+</pre>
+The official manual has a typo where the [[zero flag]] is cleared instead.
 === See Also ===
 * [[EI]]
+* [[RETI]]
+* [[BRK (SPC700)]]
 * [[SEI]]
+* [[CLI]]
 === External Links ===
 * Official Super Nintendo development manual on DI: Table C-19 in [https://archive.org/details/SNESDevManual/book1/page/n235 Appendix C-10 of Book I]
+* anomie: https://github.com/yupferris/TasmShiz/blob/master/spc700.txt#L424
 [[Category:ASM]]
 [[Category:SPC700]]
 [[Category:Program Status Flag Operation Commands]]
+[[Category:One-byte Instructions]]