XOR (Super FX): Difference between revisions
(assuming 1) |
(same as which OR) |
||
| Line 42: | Line 42: | ||
In this article, we assume the information in [1] is correct. | In this article, we assume the information in [1] is correct. | ||
It probably restores the [[ALT0]] state like [[OR]]. The speeds are probably the same as OR as well. | It probably restores the [[ALT0]] state like [[OR]]. The speeds are probably the same as two byte OR as well. | ||
The low nybble of the opcode specifies either the immediate value or which general register to use, like OR. We can deduce this by contradiction because if it were the high nybble instead, [[RPIX]] would have the same opcode as XOR R<sub>4</sub> making them indistinguishable. | The low nybble of the opcode specifies either the immediate value or which general register to use, like OR. We can deduce this by contradiction because if it were the high nybble instead, [[RPIX]] would have the same opcode as XOR R<sub>4</sub> making them indistinguishable. | ||
Revision as of 09:37, 22 July 2024
| Basic Info | |||||||
|---|---|---|---|---|---|---|---|
| Addressing Mode | Opcode | Length | Speed | ||||
| Immediate | 3FCn | 2 bytes | |||||
| Implied (type 1) | 3DCn | 2 bytes | |||||
| Flags Affected | ||||||||
|---|---|---|---|---|---|---|---|---|
| B | ALT1 | ALT2 | O/V | S | CY | Z | ||
| 0? | 0? | 0? | .? | ? | .? | ? | ||
XOR is a poorly documented (XOR is mentioned on page 2-2-7 of Book II of the Nintendo documentation and in the index) Super FX instruction that performs an exculsive or.
In this article, we assume the information in [1] is correct.
It probably restores the ALT0 state like OR. The speeds are probably the same as two byte OR as well.
The low nybble of the opcode specifies either the immediate value or which general register to use, like OR. We can deduce this by contradiction because if it were the high nybble instead, RPIX would have the same opcode as XOR R4 making them indistinguishable.
HIB's opcode is C0 and it appears to not care whether ALT1/ALT2 are set. If that is the case, then we can conclude that like OR, R0 is not available as XOR's operand and neither can zero be the immediate value. (But R0 can still be the source register.)
The source and destination registers should be specified in advance using WITH, FROM, or TO. Otherwise, R0 serves as the default.
Syntax
XOR Rn XOR #n
See Also
References
- https://en.wikibooks.org/wiki/Super_NES_Programming/Super_FX_tutorial#Instruction_Set_Table
- Example 3 on page 2-8-10 of Book II of the official Super Nintendo development manual
- index, lbid. https://archive.org/details/SNESDevManual/book2/page/n412