We've just updated MediaWiki and its underlying software. If anything doesn't look or work quite right, please mention it to us. --RanAS

BRK: Difference between revisions

From SnesLab
Jump to: navigation, search
(used to be considered one byte)
(shortened description)
 
Line 47: Line 47:
|}
|}


'''BRK''' (Break) is a 65x instruction that triggers a software interrupt.  The byte following the opcode is called the [[signature byte]].  The state of the [[interrupt disable flag]] has no effect on the behavior of BRK although it will be set after BRK runs.  In other words, BRK causes an [[NMI]].
'''BRK''' (Break) is a 65x instruction that triggers a non-maskable software interrupt ([[Non-Maskable Interrupt|NMI]]).  The byte following the opcode is called the [[signature byte]].  The state of the [[interrupt disable flag]] has no effect on the behavior of BRK although it will be set after BRK runs.


Control is routed to the BRK handler, whose address is stored at the BRK vector:
Control is routed to the BRK handler, whose address is stored at the BRK vector:

Latest revision as of 02:03, 23 August 2024

Basic Info
Addressing Mode Opcode Length Speed
Stack (Interrupt) 00 2 bytes 8 cycles*
Flags Affected
N V M X / B D I Z C
65c816 native mode . . . . 0 1 . .
6502 emulation mode . . . 1 0 1 . .

BRK (Break) is a 65x instruction that triggers a non-maskable software interrupt (NMI). The byte following the opcode is called the signature byte. The state of the interrupt disable flag has no effect on the behavior of BRK although it will be set after BRK runs.

Control is routed to the BRK handler, whose address is stored at the BRK vector:

  • In native mode, this vector is at $00:FFE6.
  • In emulation mode, this vector is at $FFFE.

The PBR is cleared, but in native mode its previous value is pushed to the stack.

Syntax

BRK
BRK sig

Cycle Skipped

BRK takes one fewer cycle in emulation mode as it doesn't need to push the program counter bank register to the stack.

If the signature byte was omitted from the assembler source, then it ends up serving double duty as the opcode of the next instruction. In this case the interrupt handler must decrement the return address on the stack so that the eventual RTI does not cause derailment.

brk.png

BRK used to be considered a one-byte instruction in an early datasheet.

See Also

External Links